Yamaha DSP A5 Amp. Remote Fault

Discussion in 'Computer Support' started by CJ, Oct 22, 2003.

  1. CJ

    CJ Guest

    Hi,

    I have a Yamaha DSPA5 Surround amp with a RAV211 remote control. Suddenly several of the
    buttons on the remote have stopped working. eg. Play,Test,1,9,0,Rewind. The remote is
    about 2 1/2 years old and hasn't had a lot of use. The fault was sudden. I have changed
    the batteries. Has anyone else had a similar problem and found a simple fix. I have
    e-mailed Yamaha who were very helpful and said "Unfortunately it sounds very much like the
    remote has developed a fault, best pop the handset into your dealer so that they can
    investigate further."

    Thanks in advance,

    CJ
     
    CJ, Oct 22, 2003
    #1
    1. Advertisements

  2. CJ

    Ian Molton Guest

    perhaps it got damp?

    Assuming it has the typical 'squidge-pad' keypad, open it, and clean the
    contacts on the PCB off using a kitchen towel and some alcohol. be
    careful not to leave lint behind.

    also clean the keypad itself, including the little conductive rubber
    pads.

    HTH.
     
    Ian Molton, Oct 22, 2003
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.