Warning, failover ip address is not configured for intf* interface

Discussion in 'Cisco' started by Sergio Rivera Villarreal, Apr 3, 2004.

  1. Sergio Rivera Villarreal

    Sergio Rivera Villarreal Guest

    Greetings,

    I'm configuring a pix 525 with failover, and i'm getting the next
    message in all the interfaces:
    Warning, failover ip address is not configured for intf interface



    Someboy has seen something like that...

    TIA!!..
     
    Sergio Rivera Villarreal, Apr 3, 2004
    #1

    1. Advertisements

  2. Sergio Rivera Villarreal

    Rik Bain Guest

    If you have an interface in a non-shutdown state, then "failover ip
    address" must be configured. If you are not using an interface and it is
    shutdown, then failover ip address for that interface can remain 0.0.0.0.

    Rik Bain
     
    Rik Bain, Apr 3, 2004
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Networking is not installed or not configured properly

  2. Stateful NAT failover = yes. Stateful CBAC failover = ????

  3. Static IP adress for adhoc nw is not configured / shows not in "ifconfig /all" !

  4. Changing pix configs when failover is configured

  5. Regarding to HSRP configured on VLAN Interface.

  6. PIX 7.2: IKE Initiator unable to find policy: Intf 1..

  7. useing the through traffic interface for Failover interface

  8. Configured 2 E1 BRI failover

Loading...