VWIC-1MFT-T1 and splitting voice (Callmanager) and Data (Frame Relay)

Discussion in 'Cisco' started by jaarons, Mar 31, 2005.

  1. jaarons

    jaarons Guest

    I'm still new to the VWIC-1MFT-T1, but I understand my customer can
    order a combo T1 from ITC DeltaCom (US Telco) where I can get 6
    channels voice (configured as H.323 for Callmanager) and 8 channels
    data (512k Frame Relay) and split them out inside the 2800 ISR with the
    MFT card.

    Another engineer suggested I needed the WVIC-2MFT-T1-DI but I thought
    that was only if I had an older PBX and wanted to provide a PRI to that
    (according to the CCO docs on DI (Drop/Insert).

    -jason
     
    jaarons, Mar 31, 2005
    #1
    1. Advertisements

  2. jaarons

    thrill5 Guest

    You are correct. The Drop/Insert is used if you want to send the voice
    channels to a device other than the router, such as a PBX.

    Scott
     
    thrill5, Apr 1, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.