VPN to PIX via ADSL modem in router mode

Discussion in 'General Computer Support' started by tania26, Jul 6, 2009.

  1. tania26

    tania26

    Joined:
    Jul 6, 2009
    Messages:
    1
    Likes Received:
    0
    I have the following connection schema:

    LAN-(192.168.0.0) == (192.168.0.1)-SonicWall-(192.168.5.5) == (192.168.5.1)-ADSL modem-(95.33.44.55) == Internet == (208.66.77.88 )-PIX 515-(10.0.0.1) == (10.0.0.0) LAN

    The VPN connection between SonicWall and PIX is established but the traffic does not flow, even pings.
    There is "VPN tunnel end point does not match configured VPN Policy Bound to scope" message in SonicWall's logs.

    I have another Internet connection which assigns public IP directly to SW. In this case the tunnel works perfectly.

    ADSL modem is Zyxel P660 and configured in Routing mode (Bridging is not allowed by the ISP) and NAT is turned on.
    I cannot throw out ADSL modem and use second line as since need two connections for possible fail over. I think that the cause is in this NAT mode but haven't found the solution yet.
    Can anyone help me with PIX configuration for my case?

    Thank you in advance.
     
    tania26, Jul 6, 2009
    #1

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. PIX to PIX VPN and VPN Client to PIX Config Example?

  2. Pix-Pix vpn via cisco 828 router

  3. VPN to Pix via modem

  4. VPN PIX-_static PIX ; PIX-dynamic_PIX ; VPN Client

  5. Cisco 3640 NM-4E Westell ADSL Modem & Ambit Cable Modem/Router Half 1/2 Speed

  6. adsl pci modem, and adsl ethernet modem

  7. (router + adsl modem) versus (router with built in adsl modem)

  8. adsl router to adsl router

Loading...