useing the through traffic interface for Failover interface

Discussion in 'Cisco' started by Talal, Jun 6, 2007.

  1. Talal

    Talal

    Joined:
    Jun 6, 2007
    Messages:
    1
    Likes Received:
    0
    Hi,
    All 4 5520 ASA interface is used for different segment and want to configure the failover port for HA so is there any to do this without adding the new 4GE SSM module by using managment port or one of traffic port to handle HA heartbeat.

    In netscreen you can do this by secondary IP option but in ASA this feature not available.

    thanks,
     
    Talal, Jun 6, 2007
    #1

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. limited or no connectivity xphome useing bt2110 router

  2. copy tftp to switch by useing snmpset

  3. Stateful NAT failover = yes. Stateful CBAC failover = ????

  4. How to config two Cisco PIX devices to allow multicast traffic through the VPN tuunel between the tw

  5. routing traffic through dsl modem connected to router ethernet interface

  6. Useing Laptop away from home.

  7. Need to route SMTP traffic through static interface (not default route)

  8. cisco ASA/PIX failover and VPN, failover IP access problem

Loading...