Terminal Server Problem (break sequence)

Discussion in 'Cisco' started by CCIE Wannabe, Oct 4, 2004.

  1. CCIE Wannabe

    CCIE Wannabe Guest

    Greetings,

    I have two 2522 routers set up as terminal servers. The first
    router, ConsoleA has reverse telnet mapping to ConsoleB, which in turn
    has another 7 devices connected to it. Being that a break sequence
    (Ctrl-Shift-6, x) will break the session from anything below router
    consoleB, I need to change this. Is this possible? I want to change
    the break sequence from consoleB to something like Ctrl-shift-6, q. If
    this is possible, can someone tell me exactly how to do this? From the
    line con 0 config mode you can only enter a single ASCII binary
    representation. HELP!!


    erich
     
    CCIE Wannabe, Oct 4, 2004
    #1
    1. Advertisements

  2. CCIE Wannabe

    Hansang Bae Guest

    you can with 'escape-char'. But you don have to. CS6, CS6, then X will
    take you out one level. or CS6, CS6, CS6, then X will take you out one
    more level.

    --

    hsb

    "Somehow I imagined this experience would be more rewarding" Calvin
    *************** USE ROT13 TO SEE MY EMAIL ADDRESS ****************
    ********************************************************************
    Due to the volume of email that I receive, I may not not be able to
    reply to emails sent to my account. Please post a followup instead.
    ********************************************************************
     
    Hansang Bae, Oct 5, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.