TCP/UDP port or protocol-based routing

Discussion in 'Cisco' started by J, Feb 6, 2006.

  1. J

    J Guest

    Greetings. Does anyone here have any ideas for routing traffic based
    on the protocol or tcp/udp port numbers? For example I have a site
    that needs to route all outbound SMTP and FTP traffic onto one circuit
    and all SSH, Telnet, NTP, DNS and HTTP traffic onto another circuit.
    They are most concerned with routing highly interactive protocols like
    SSH and telnet over the higher-speed lower-latency circuit and keeping
    most of the bandwidth hogs on another circuit. I'm not just talking
    about setting precedence and priority but literally segementing off
    specific types of traffic from one another. I've been looking at
    various route-map options but I haven't been able to find any layer-4
    filtering options (tcp/udp port #). That is unless the "match ip
    address" command will match against an ACL that defines destination
    port instead of IP. The destinations for this type of traffic varies
    wildly. I don't have a lab with which I can test this on at the
    moment. Does anyone else have any ideas? Thanks


    J
     
    J, Feb 6, 2006
    #1
    1. Advertisements

  2. J

    Merv Guest

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.