tcl 2.0 ivr problem

Discussion in 'Cisco' started by Joe Gonzalez, Sep 16, 2004.

  1. Joe Gonzalez

    Joe Gonzalez Guest

    I'm not sure if this is the correct forum to post this question, but
    hopefully someone can help.

    I have a cisco 5300 running 12.3(9a) and a tcl script that I wrote that
    works fine. I was trying to get the remote ip address of the incoming
    voip call leg but the infotag "leg_remoteipaddress" is always blank.
    This is how I'm trying to use the tag:

    set remoteip [infotag get leg_remoteipaddress leg_incoming]

    But remoteip is always blank. The same goes for
    leg_remote_media_ip_address and leg_remote_signaling_ip_address. Does
    anyone have any clue? Thanks for any help!

    Joe Gonzalez
    - is it lunchtime yet?
    Joe Gonzalez, Sep 16, 2004
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.