Strange behavior Ethernet0 on 837?

Discussion in 'Cisco' started by AM, Sep 6, 2005.

  1. AM

    AM Guest

    Hola a todos,

    let me explain what happened:

    I build a VPN tunnel from a remote device to my 837. I controlled all the VPN configuration and I seemed OK. But I could
    not try completed (my test should have been a ping from a host behind 1 device to the ethernet0 interface of the router).
    As there weren't any workstations connected to the switch on the rear of the router ETH0 was down.
    I did a workaround leaving eth0 with no ip address and giving its to a loopback interface.
    I completely saw that VPN was successfully configured. When I rolled back the situation (I mean deleted loopback and
    given its IP to eth0) I expected not to be able to ping the eth0 from remote.
    Magically I did! Right now I can but there are not workstation up and running (ping failed and sh arp output is empty).

    How that is possible?

    Alex.
     
    AM, Sep 6, 2005
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.