Site to Site VPN routing - Cisco 1841 to Nortel VPN Router 1010

Discussion in 'Cisco' started by peachmach5, Sep 21, 2007.

  1. peachmach5

    peachmach5 Guest

    I am trying to connect a Cisco 1841 router to a Nortel VPN Router 1010
    via a IPSEC VPN tunnel. I actually have the tunnel up and running.
    My problem is that I cannot figure out how to tell the Cisco Router to
    route traffic from its private network to the private network on the
    Nortel Router. The Nortel Router seems to just route traffic to the
    Cisco Router's public interface and it works. If I put a static route
    in the Cisco Router to route to the Nortel Router's public interface,
    I get nothing. Any help would be appreciated.
    peachmach5, Sep 21, 2007
    1. Advertisements

  2. peachmach5

    Merv Guest

    take a look at IPSec Virtual Tunnel Interface

    Static Virtual Tunnel Interfaces figure 1

    Notice the static route pointing to the tunnel interface
    Merv, Sep 21, 2007
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.