Setting E1 VWIC cards to ATM mode for Inverse multiplexing over ATM(IMA)

Discussion in 'Cisco' started by Ivan82, Aug 29, 2006.

  1. Ivan82

    Ivan82 Guest

    Show version gives me this:
    Cisco Internetwork Operating System Software
    IOS (tm) C2600 Software (C2600-IS-M), Version 12.1(22c), RELEASE
    SOFTWARE (fc1)
    Copyright (c) 1986-2004 by cisco Systems, Inc.
    Compiled Thu 01-Apr-04 18:05 by pwade
    Image text-base: 0x80008088, data-base: 0x80CDB1BC

    ROM: System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)

    router01 uptime is 10 minutes
    System returned to ROM by power-on
    System image file is "flash:c2600-is-mz.121-22c.bin"

    cisco 2610 (MPC860) processor (revision 0x00) with 30720K/10240K bytes
    of memory.
    Processor board ID J----------- (-----------------)
    M860 processor: part number 0, mask 49
    Channelized E1, Version 1.0.
    Bridging software.
    X.25 software, Version 3.0.0.
    Primary Rate ISDN software, Version 1.1.
    1 Ethernet/IEEE 802.3 interface(s)
    2 Channelized E1/PRI port(s)
    32K bytes of non-volatile configuration memory.
    16384K bytes of processor board System flash (Read/Write)

    I have 2 VWIC E1 cards, one AIM-ATM card and an IP PLUS version of the
    IOS. I've been told the commands to get the E1 interfaces into ATM mode
    are the following:

    Router#conf t
    Router(config)#controller E1(slot/port) es. 1/0
    Router(config-controller)mode atm aim (slot)

    But there seems to be no 'mode' command!! What am I doing wrong?

    Ivan82, Aug 29, 2006
    1. Advertisements

  2. Hi Ivan,

    You may wish to investigate:

    Set the E1 controller into ATM mode:

    Hope this helps.

    Brad Reese
    Cisco IOS Software - Compatible Partner Matrix by Technology
    1293 Hendersonville Road, Suite 17
    Asheville, North Carolina USA 28803
    USA & Canada: 877-549-2680
    International: 828-277-7272
    Fax: 775-254-3558
    AIM: R2MGrant
    BradReese.Com - Global Cisco Systems Pre-Sales Support
    www.BradReese.Com, Aug 29, 2006
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.