Routing Question - How to send default internet traffic to PIX and VPN traffic from router out inter

Discussion in 'Cisco' started by Evolution, Feb 27, 2007.

  1. Evolution

    Evolution Guest

    This is the scenario:

    I have a network with Subnet: 192.168.1.0/20
    A Cisco 1841 Exists as the default Gateway: 192.168.1.1 Fa0/1, Fa0/2
    is 66.43.54.111
    A PIX 501 Exists to filter traffic: 192.168.1.254 Inside, 66.43.55.20
    Outside

    The route so far is 0.0.0.0 0.0.0.0 192.168.1.254, This sends all
    traffic out through the PIX 501

    If I want the router to be able to access the internet, but not
    through the PIX 501, how would I set this up. The next hop router for
    66.43.54.111 is 66.43.54.1.

    Need a solution since the router already has 0.0.0.0 0.0.0.0
    192.168.1.254 in it.

    Any help would be greatly appreciated! Thanks.

    -Rodney
     
    Evolution, Feb 27, 2007
    #1

    1. Advertisements

  2. Evolution

    Walter Roberson Guest

    I'm confused. Do you have the router and PIX in parallel, both
    connected to an outside device (e.g., a switch or second router),
    or are the two connected to different ISPs, or are the two in series??
     
    Walter Roberson, Feb 27, 2007
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. PIX to PIX VPN and VPN Client to PIX Config Example?

  2. encapsulation dot1q native keyword and inter-vlan routing problem

  3. Access Lists And Inter vlan routing

  4. Inter-VLAN routing performance on the 1711 router

  5. same-security-traffic permit inter-interface PIX 501 cli 6.3

  6. Inter-Vlan Routing question

  7. Inter VLAN routing with a 2611 router

  8. Cannot send traffic out vpn tunnel

Loading...