Reset Supervisor Engine 720 to factory defaults ??

Discussion in 'Cisco' started by Tobias Kines, Nov 21, 2005.

  1. Tobias Kines

    Tobias Kines Guest

    Hello,

    how do i reset a Supervisor Engine 720 to the factory defaults ?

    Thank you very much in advance,
    Tobias
     
    Tobias Kines, Nov 21, 2005
    #1
    1. Advertisements

  2. Tobias,

    You can just erase startup config and reboot the card. It will bring the
    card to the "factory default" state.

    If you have a card in "hybrid" mode, you need to remove the main startup
    config (in this mode you have one interface to both, switch and router
    functionality). If you have a card in the Native mode, then you have to
    remove configs in both modes - in the router and in the switch.

    Good luck,

    Mike
    www.ciscoheadsetadapter.com
     
    CiscoHeadsetAdapter.com, Nov 22, 2005
    #2
    1. Advertisements

  3. Tobias Kines

    Tobias Kines Guest

    Thanks Mike

    Have a nice day,
    Tobias
     
    Tobias Kines, Nov 22, 2005
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.