Ran out of uplinks

Discussion in 'Cisco' started by shymin23, Jan 16, 2012.

  1. shymin23

    shymin23

    Joined:
    Dec 29, 2011
    Messages:
    4
    Likes Received:
    0
    Hi,

    Below is the scenario I wish to create.

    I have a distribution switch which is the core switch for floor switches. All the floor switch vlans are created on this distribution switch. The distribution switch is in a different building from the floor switches. Distribution switch is in Bldg A. Floor switches are in Bldg B. There are total 5 cables running between the the two buildings. 4 of these cables are used for uplink to the floor switches. I have to connect 1 device from Bldg B directly to the distribution switch using this uplink cable. I have to connect another switch from Bldg B to distribution switch in Bldg A but in a different vlan from the other floor switches. The diagram is attached below. I am falling short of uplinks.

    How to achieve both the connectivity by configuring the switches.
     

    Attached Files:

    shymin23, Jan 16, 2012
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.