Problem with Catalyst 6500 and HP Auto Port Agregation protocol

Discussion in 'Cisco' started by khalil, Jul 8, 2005.

  1. khalil

    khalil Guest

    Hello

    After upgrading software in my catalyst 6500 to version IOS 12.1(23)E3
    i have found out that all servers using APA in Lan Monitor mode
    failed. APA is unable to be established. Standby NIC use speciall
    frames in L2 to periodically check if the second NIC (active) if it is
    still working, and it seems that after upgrade such frames do not pass
    the switch. They get into the switch for sure, because there are MAC
    addresses of the NIC`s in mac-address table, but when I sniff traffic
    on the trunk connecting 2 CATALYST`S I don`t see them.
    I do not know if it is a problem with software or anything else. If
    anybody meet the same problem please let my know how to fix it.

    Thx in advance
    Lukas
     
    khalil, Jul 8, 2005
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.