Pix 515 Configuring Multiple External Interfaces

Discussion in 'Cisco' started by RG, May 26, 2010.

  1. RG

    RG Guest

    I have a total of 3 physical interfaces. 2 of them external and one
    internal.
    One external interface ip is xx.xx.xxx.251. The other external interface ip
    192.168.3.3.
    The internal interface ip is 192.168.1.3.

    I have successfully setup all inside traffic going out to wan to be routed
    through external interface ip192.168.3.3.
    Now, I would like to route from inside to xx.xx.xxx.248/29 through external
    interface ip xx.xx.xxx.251 and the rest of the outside traffic should be
    routed through external interface ip ip192.168.3.3.

    How can I accomplish that? Thanks in advance.

    natfg is 192.168.3.3
    tpfg is xx.xx.xxx.251
    inside is 192.168.1.3

    global (natfg) 1 interface
    nat (inside) 1 192.168.1.11 255.255.255.255
    nat (inside) 1 192.168.1.16 255.255.255.255
    nat (inside) 1 192.168.1.129 255.255.255.255
    static (inside,tpfg) tcp xx.xx.xxx.251 https 192.168.1.16 https netmask
    255.255.255.255
    static (inside,tpfg) tcp xx.xx.xxx.251 smtp 192.168.1.16 smtp netmask
    255.255.255.255
    access-group workstations in interface inside
    access-group inbound in interface tpfg
    route natfg 0.0.0.0 0.0.0.0 192.168.3.3 1
     
    RG, May 26, 2010
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.