one physical interface appears twice in run conf

Discussion in 'Cisco' started by Christian Lox, Dec 7, 2004.

  1. Christian Lox

    Christian Lox Guest

    Hi!

    I am having trouble with a 7507 running 12.0.30(S).
    After having done a 'redundancy force-switchover' pur FastEthernet
    0/0 did not come up.
    A quick look in running config shows that it appears twice, both
    times without ip etc...
    When I set up an ip address it wont work, because the second entry
    remains empty.
    show interfaces says:
    FastEthernet0/0 is up, line protocol is up
    Hardware is not present
    Hardware is cyBus FastEthernet Interface and so on

    What can I do to get my interface back (the real one :) ?

    Thanks in advance,
    Christian
     
    Christian Lox, Dec 7, 2004
    #1

    1. Advertisements

  2. Christian Lox

    Ben Guest

    It may be a bug, but you can probably fix it via a reload. If this is a
    VIP interface (?) you might try reloading the card. If there's no
    special reason to be running 12.0(30)S I would drop down to say 12.0(27)S3.
     
    Ben, Dec 8, 2004
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Termination of an IPSec VPN tunnel and a GRE Tunnel on one physical interface.

  2. DNS problem, suspect PIX conf

  3. Port Forwarding -> Special Conf for PIX

  4. Two ISPs, One 3640 Router, and PIX 515 with one outside interface

  5. Yawn. One more crummy P&S appears

  6. Access to network through physical interface

  7. Error: Physical sythesis tool PALAC is not supported by Formal Verification tool Conf

  8. Number of files on the machine appears TWICE the real number

Loading...