Obtaining speeds on rate limited circuits over ATM PVC's (Cisco) via SNMP

Discussion in 'Cisco' started by alanknipmeyer, Apr 28, 2005.

  1. alanknipmeyer

    alanknipmeyer Guest

    Hiya,

    I have the current setup whereby I have a DSL(ATM/PVC) interface of 2Mb
    which is limited to 256K, when I pull off the IF index, it correctly
    reports it as 2Mb. Is there a way to get the rate limited value from
    the ATM Interface ? I cant seen anything within Cisco's ATM Mibs which
    can pull this off..

    Thanks in advance,

    Al.
     
    alanknipmeyer, Apr 28, 2005
    #1

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. ATM PVC on Cisco 7140

  2. Cannot make a BVI on an ATM PVC/catalyst 6500 work!

  3. OID for ATM circuits?

  4. bridging between 2 ATM subinterfaces/PVC's

  5. splitting ATM PVC between different routers

  6. Setting E1 VWIC cards to ATM mode for Inverse multiplexing over ATM(IMA)

  7. Shaping ATM PVC in 12.4T

  8. cisco 877 atm pvc config for QOS

Loading...