Need Help setting routes on Cisco 2514 router

Help!
I have the following.

Subnet 1
Internet ----------Linksys
router(192.168.1.1)-----hub----(192.168.1.100)Cisco2514
eth0------------continued below


Subnet 2
--------------------Cisco2514 eth1 (192.168.2.100)---------hub


I need to be able to set routes so Windows pcs on the 192.168.1.x
subnet can talk to pcs on the 192.168.2.x subnet. Also, pcs on
192.168.2.x should be able to talk top 192.168.1.x and the internet
via 192.168.1.1.

Here the the sh ip route info:

Router>sh ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B -
BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * -
candidate default
U - per-user static route, o - ODR

Gateway of last resort is not set

C 192.168.1.0/24 is directly connected, Ethernet0
C 192.168.2.0/24 is directly connected, Ethernet1

Notice the route to the internet is missing (192.168.1.1), how do I
set it? Also from 192.168.1.x netowrk I cannot ping 192.168.1.100
router interface and the same from 192.168.2.x netowrk, I cannot ping
the 192.168.2.100 interface on the router.

 

Actually the route to 192.168.1.1 is there; it is the first route
listed
(C 192.168.1.0/24 is directly connected, Ethernet0)

However you do not have a default route configured on the 2514

this done by entering the commands:
conf t
ip route 0.0.0.0 0.0.0.0 192.168.1.1exit
wri mem
You will also need to configure route on the Linksys router so it
know how to find the 192.168.2.0 via 192.168.1.100
You perhaps you should post the 2514 config here without passwords