NAT not Translating

Discussion in 'Cisco' started by Jebez42, Sep 5, 2008.

  1. Jebez42

    Jebez42

    Joined:
    Sep 4, 2008
    Messages:
    3
    Likes Received:
    0
    From the diagram below, I would like to dynamic nat 192.168.64.0/22 as 10.21.3.0/24 on routerWAN.

    I configured as shown in configuration below; and router3 traffic (192.168.64.0/22) is still accessing router1 hosts (10.200.0.0/16), but I see no translations occurring on routerWAN (via sh ip nat stat/tran). Please advise.


    routerWAN# show ip nat translations

    routerWAN# show ip nat statistics
    Total active translations: 0 (0 static, 0 dynamic; 0 extended)
    Outside interfaces:
    GigabitEthernet0/0, GigabitEthernet0/1
    Inside interfaces:
    FastEthernet1/3
    Hits: 0 Misses: 0
    CEF Translated packets: 0, CEF Punted packets: 0
    Expired translations: 0
    Dynamic mappings:
    -- Inside Source
    [Id: 1] access-list 3 pool router3 refcount 0
    pool router3: netmask 255.255.255.0
    start 10.21.3.129 end 10.21.3.254
    type generic, total addresses 126, allocated 0 (0%), misses 0
    Queued Packets: 0

    {configuration and diagram in attachment}
     
    Jebez42, Sep 5, 2008
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.