Multiple access point cross floor

Discussion in 'Cisco' started by yellow, Mar 13, 2006.

  1. yellow

    yellow Guest

    Hi,

    I've a site will setup multiple access point (Cisco ap1231) on 2
    different floors (3 aps on 1st floor & 2 aps on 2nd floor). One of the
    ap on 1st floor acts as a root and the other will be repeater. On 2nd
    floor, the radio signal couldn't be detected by any ap on 1st floor,
    but there's a switch linked to 1st floor. Can I connect these ap to
    that switch, setup these 2 aps as repeater thru the wired connection ?
    or any other suggestion ?

    Many thanks !
     
    yellow, Mar 13, 2006
    #1
    1. Advertisements

  2. yellow

    Merv Guest

    You should try to home run each AP to a switch and not use repeater
    mode.

    Make sure you alternate the channels based on the site layout.
     
    Merv, Mar 13, 2006
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.