MCI Datacenter handoff connected to Cisco 2950 Switch

Discussion in 'Cisco' started by fesbert, Apr 23, 2005.

  1. fesbert

    fesbert Guest

    I just aquired a cisco 2950 switch for our datacenter. We previously
    had a low end linksys switch which worked ok. When I switched the line
    that comes from the datacenter switches I get no link on the port. The
    link coming in is a 10 baseT. We got a tiered T1 1536 mbps bandwidth.
    It works fine with the other switch.
    Any ideas? I only need this switch to do layer 2. Is there any special
    configuration I need to configure on that port?

    Thanks in advance.
     
    fesbert, Apr 23, 2005
    #1
    1. Advertisements

  2. fesbert

    Nick Guest

    Sorry for the question but did the linksys switch have a "crossover"
    port you were using? If so, you will need to swap out the cable for a
    crossover.
     
    Nick, Apr 23, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.