Load balancing on leased lines

Discussion in 'Cisco' started by Rana, Oct 31, 2006.

  1. Rana

    Rana Guest

    0Dear All:

    We have two locations connected through two routers via two DXX(digital
    cross connect) leased lines. The two lines connecting the same two
    locations. Does anybody knows how to use both circuits for data
    traveling simultanously. Becouse i've noticed that the both circuit are
    up but data goes from one serial instead off going to both serial.

    We are using eigrp protocol on CISCO 2620XM routers

    waiting for a reply.

    Rana, Oct 31, 2006
    1. Advertisements

  2. Rana

    genki Guest


    You can use the eigrp "variance" command for unequal cost load
    genki, Oct 31, 2006
    1. Advertisements

  3. Hello,

    I can recommend following book:

    Routing TCP/IP Vol 1 - 2nd Edition, Jeff Doyle, Jennifer Carroll, Cisco

    There is Load Sharing and Load Balancing described.

    Georg Dingler, Nov 1, 2006
  4. Rana

    fazer Guest

    fazer, Nov 2, 2006
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.