Load balance between two parallel paths

Discussion in 'Cisco' started by kazdan, Jun 21, 2006.

  1. kazdan

    kazdan Guest

    hey guys, i have a topology which looks thusly:

    Router
    / \
    / \
    \ /
    \ /
    Router

    both paths are tunnels, I would like to load balance between these two
    cisco 3550 catalysts with ip routing enabled, so that not only will it
    load balance but it will do so intelligently, it will distribute
    packets according to load on bandwidth and so on. I am aware that i
    could use variance to allow a worse connection to help in load balance
    but i would prefer if the load were balanced so that the proportions
    are calculated and possibly dynamic. Is this possible and if so what
    are the commands necessary?
     
    kazdan, Jun 21, 2006
    #1
    1. Advertisements

  2. kazdan

    PepeRdguez Guest

    ha escrito:
    Did you visit this site?
    http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094820.shtml
    Be aware about routers process load in case you chose the best traffic
    balance, which is on packet basis.

    Good luck
     
    PepeRdguez, Jun 21, 2006
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.