L2L tunnel, concentrator 3000 to PIX ?

Discussion in 'Cisco' started by paul814@excite.com, May 1, 2008.

  1. Guest

    I am trying to setup my concentrator to connect to a PIX over the
    internet and create a tunnel.

    I have used directions here:
    http://www.cisco.com/en/US/products...s_configuration_example09186a00800949d2.shtml

    the remote end, the pix is all setup, but they can not ping any
    devices on my end. We have setup a route on our core router....still
    nothing.

    looks like I can get through step 6 OK on the instructions, but step
    7, I never get anywhere that has an apply.

    Any one offer any help?
     
    , May 1, 2008
    #1
    1. Advertisements

  2. <> wrote in message
    news:...
    >I am trying to setup my concentrator to connect to a PIX over the
    > internet and create a tunnel.
    >
    > I have used directions here:
    > http://www.cisco.com/en/US/products...s_configuration_example09186a00800949d2.shtml
    >
    > the remote end, the pix is all setup, but they can not ping any
    > devices on my end. We have setup a route on our core router....still
    > nothing.
    >
    > looks like I can get through step 6 OK on the instructions, but step
    > 7, I never get anywhere that has an apply.
    >
    > Any one offer any help?


    hard with no posted actually configs.
    But if you use NAT applt ISAKMP NAT-T command in both ends.

    HTH
    Martin
     
    Martin Bilgrav, May 1, 2008
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.