IOS 12 timeout problem with dialer-list x protocol ip list y

Discussion in 'Cisco' started by Holger Isenberg, Nov 19, 2003.

  1. Holger Isenberg

    Holger Isenberg Guest

    The dial-on demand dialout with NAT over the 1603 with OS 12 works
    fine, except that the idle timeout is not updated by "NATed" packets.
    The connection can only be established by ip-packets from a host in
    access-list 101, as configured.

    However, further packets from the same host do not reset the
    idle-counter to its initial value.

    config:

    interface Ethernet0
    ip address 192.168.1.0 255.255.255.0
    no ip redirects
    no ip directed-broadcast
    ip nat inside

    interface BRI0
    ...
    dialer idle-timeout 600
    dialer-group 1

    ip nat inside source list 101 interface BRI0 overload
    access-list 101 permit ip host 192.168.1.10 any
    dialer-list 1 protocol ip list 101

    After connecting, the following
    #cisco1603 show dialer

    does not show the Time until disconnect reset to 600 when packets are
    send out:

    BRI0:1 - dialer type = ISDN
    ...
    Time until disconnect 432 secs
    ...

    Any idea what's wrong?
     
    Holger Isenberg, Nov 19, 2003
    #1

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Protocol Chart - Learn how to use a Protocol Analyzer

  2. Dialer with 2 different dialer strings, second channel fails

  3. use of the same "dialer called 12345" in multiple dialer interfaces

  4. 804 Packet loss during dialer idle timeout process?

  5. instructions on how to perform an IOS upgrade on a Catalyst 6500 switch (IOS to IOS)

  6. Dialer Idle Timeout Not Working

  7. setting dialer enable-timeout with dialer profiles

Loading...