instructions on how to perform an IOS upgrade on a Catalyst 6500 switch (IOS to IOS)

Discussion in 'Cisco' started by Mike Rahl, May 30, 2007.

  1. Mike Rahl

    Mike Rahl Guest

    Hi, all

    Does anyone know of a link on Cisco's site that explains how to
    perform an IOS upgrade (all the steps) for a Catalyst 6500 switch with
    a Sup2 card (any kind), and an MSFC card?

    I went looking all over Cisco and google yesterday, and can't seem to
    find it. I was able to finish the upgrade through trial and error, but
    would like to see if there is a document that explains the best
    practices, and my searches didn't come up with anything useful

    I'm looking for primarily the configuration steps as well as how to
    copy the files, which files are required, and to which flash memory
    locations on the switch

    Thanks very much!
     
    Mike Rahl, May 30, 2007
    #1

    1. Advertisements

  2. Mike Rahl

    Trendkill Guest

    http://www.cisco.com/en/US/products...s_configuration_example09186a0080116ff0.shtml
     
    Trendkill, May 30, 2007
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Catalyst 6500 Native IOS question

  2. Catalyst 6500 Content Switch Module

  3. Cat 6500 to Cat 6500 and VLANs

  4. How to manage IP address and how to perform subnetting, i have a good idea

  5. trunking between Cisco Catalyst 500 switch and other type of switch

  6. 6500 IOS Upgrade

  7. CISCO Catalyst 2950 Switch IOS Upgrade?

  8. Cisco IOS naming for Catalyst 6500 Series

Loading...