How to configure 2 routers in failover

Discussion in 'Cisco' started by gk99, Apr 6, 2007.

  1. gk99

    gk99

    Joined:
    Apr 6, 2007
    Messages:
    1
    Likes Received:
    0
    We're opening a remote site that's going to have a Layer3 switch and 2 Cisco 2801 routers. Each router has 2 T1's going to 2 Cisco 2801 routers at the main location. How do I setup the routers at both locations in a failover mode, so that one of the routers acts as a primary and the second router is a backup?

    On the other hand, if we do decide to run the routers in a redundant mode, how do I setup the 2 routers in each location, so that all 4 T1's are being utilized?
     
    gk99, Apr 6, 2007
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.