HELP - IP Forwarding

Discussion in 'Cisco' started by Denis, Jul 17, 2003.

  1. Denis

    Denis Guest

    Hello there,

    i have the following problem:

    CISCO 2600 with two Ethernet Interfaces

    ETH0/0: MASK
    ETH0/1: MASK

    Problem: I can't Ping from to or back

    How can I config IP forwarding

    Denis, Jul 17, 2003
    1. Advertisements

  2. Most IOS versions have IP routing enabled by default, but not all. Try
    'ip routing' in global config mode.

    Do you have the IP address of the router interface as default gateway
    configured on both machines? Can the two end stations ping their default
    gateway (router interface address) at all?


    M.C. van den Bovenkamp, Jul 17, 2003
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.