help for switch to switch connection

Discussion in 'Cisco' started by STandard, Jul 18, 2007.

  1. STandard

    STandard Guest

    Hi all,

    i have two 2950 switches, and i wanna to connect them with a Straight-
    Through cable.

    i know it should be easy to fixed by using cross cable, but my case is
    not easy to re-install cross cable =(

    so any idea, or can it be config a uplink port for one 2950 switch?

    thanks

    steve
     
    STandard, Jul 18, 2007
    #1
    1. Advertisements

  2. STandard

    briggs Guest

    So make up a six inch cross cable and crimp a male connector on one end
    and a female connector on the other.

    Or go buy a pre-built doohickey that will do the same thing. Web search for
    "Ethernet Crossover Adapter" pulls some useful hits.
     
    briggs, Jul 18, 2007
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.