Dot1Q Tunneling and VLAN Translation

Discussion in 'Cisco' started by MayaYajnik, Nov 8, 2006.

  1. MayaYajnik

    MayaYajnik Guest

    Hello
    Is it possible to do VLAN Translation on a VLAN which has dot1q tunnel
    ports? I mean that suppose I have a customer facing port,
    GigabitEthernet5/1, and I make this a dot1q tunnel port and assign it
    to VLAN 200. So now the VLAN 200 carries double tagged frames. I also
    have a trunk port called GigabitEthernet6/3, in the same network, which
    is a core trunk port which is on VLAN 200. On this port, I want to
    translate VLAN 200 to VLAN 300. Is this possible? I am using a Cisco
    Catalyst 6509 with IOS 12.2SX
    Please send example commands if possible.
    Thank you for your help!!!

    Maya
     
    MayaYajnik, Nov 8, 2006
    #1
    1. Advertisements

  2. MayaYajnik

    Guest

    Not sure, but this might help:

    http://www.riverstonenet.com/support/configdb/vlan_id_translation_w_l2.pdf

    Phillip
     
    , Nov 10, 2006
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.