Dlink DIR-655 will not allow access to my different servers from the outside.

Discussion in 'Hardware' started by dottedquad, Jun 22, 2011.

  1. dottedquad

    dottedquad

    Joined:
    Jun 22, 2011
    Messages:
    1
    Likes Received:
    0
    Hello all,
    I recently purchased a dlink DIR-655 to replace my linksys wireless G broadband router. My linksys worked flawlessly with port forwarding; however, my dlink dir-655 is not letting traffic from outside of my lan to my servers. I do have the ports forwarded and my ISP does NOT block any ports(ie: 80,20,21, etc...) which is a blessing. I verified this with the IT guy over the phone; also, I was able to access my servers with the linksys router. I am also able to access the servers using the internal lan ip address. I am assuming the addresses are configured correctly?
    I honestly do not think the router is malfunctioning and I think it is due to my configuration settings. I am stumped as to why my linksys is able to forward traffic correctly and my dlink dir-655 is not. By the way, I do not have any firewalls activated.
    Any suggestions/trouble shooting are greatly appreciated!

    -Thank You,
    Rich
     
    dottedquad, Jun 22, 2011
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.