Destination not reachable until destination pings source! PIX501

Discussion in 'Cisco' started by Dave, Feb 27, 2004.

  1. Dave

    Dave Guest

    Hi folks,

    I posted this earlier and haven't received any answers so I'm posting it
    again in case I've missed anyone.

    I have...

    Server
    193.195.10.2
    |
    SWITCH
    |
    193.195.10.1 outside
    PIX 501
    192.168.10.3 inside
    |
    |
    SWITCH (DMZ)---------192.168.10.2 Server
    |
    |
    192.168.10.1 outside
    PIX 501
    192.168.0.0 inside
    |
    SWITCH (INTERNAL)
    |
    192.168.0.10
    Server

    all routing is correct, there is no NAT, and all acl's are set to permit
    anything from anything to anything.

    Now the problem is this...

    if I try to ping from 192.168.10.2 to a destination of 192.168.0.10 it times
    out
    if I then ping from 192.168.0.10 to a destination of 192.168.10.2 it works
    then if I ping from 192.168.10.2 to a destination of 192.168.0.10 it works.
    If I reboot 192.168.10.2 it fails again until I ping it from 192.168.0.10.

    if I try to ping from 193.195.10.2 to a destination of 192.168.0.10 it times
    out
    if I then ping from 192.168.0.10 to a destination of 193.195.10.2 it works
    then if I ping from 193.195.10.2 to a destination of 192.168.0.10 it works.
    If I reboot 193.195.10.2 it fails again until I ping it from 192.168.0.10.

    can it be some sort of wierd timeout or arp on the PIX's when packets are
    coming from external

    thanks
    Dave
     
    Dave, Feb 27, 2004
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.