DD-WRT and Catalyst 2950 VLAN ACL?

Discussion in 'Cisco' started by jn0n, Dec 17, 2010.

  1. jn0n

    jn0n

    Joined:
    Dec 17, 2010
    Messages:
    1
    Likes Received:
    0
    Hello,

    Great forum here - I want to butt heads and see if I can't get my equipment to do what I want. I have a WRT54G with DD-WRT put on it and a Cisco Catalyst 2950 24 port switch. I have two VLANS setup - VLAN 1 which has clients with the 192.168.1.x subnet and VLAN 2 which has the 10.0.0.x subnet. I want to make it where VLAN 1 cannot ping VLAN 2. VLAN 2 cannot ping any host on VLAN 1, but any host on VLAN 1 can ping any host on VLAN 2. I want to cut all communication between the two VLANs and make it where any hosts on VLAN 2 can only communicate with the WRT54G via the trunk port I have configured on the 2950. I've looked around and have tried implementing some ACLs on the 2950 to no avail; I don't want to mess with the WRT54G using firewalls and what not because the Catalyst 2950 supports ACLs. I've read a lot of forum posts regarding what I want to do but I can't find an answer that works for me.

    Your guidance would greatly be appreciated :D
     
    jn0n, Dec 17, 2010
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.