Cisco AP Radius and basic rates

Discussion in 'Cisco' started by Hangas, Sep 19, 2011.

  1. Hangas

    Hangas

    Joined:
    Sep 19, 2011
    Messages:
    1
    Likes Received:
    0
    Hi,

    I have a setup with Cisco 1140 (802.11n) with radius auth using freeradius. Auth is working OK, no problems here. But....
    Before, when I only had WPA2-PSK, all 802.11n clients could connect at speeds up to MCS Index 15. Now with WPA-Enterprise with 802.11x auth, only basic rates are used.

    There were no changes on speed rates.
    To rule AP config out, I created another SSID on the same DotRadio with WPA-PSK and MCS speeds are used (up to 150mbps)

    Could some radius parameter be limiting the clients to basic rates up to 54mbps only?
    Any one with similar issues?
     
    Hangas, Sep 19, 2011
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.