Cisco Air-1130AG Flash Error?

Discussion in 'Cisco' started by Slaarne, Apr 12, 2012.

  1. Slaarne

    Slaarne

    Joined:
    Apr 12, 2012
    Messages:
    1
    Likes Received:
    0
    Hi!

    I just received a Cisco Air-1130AG access point i return from one of our customers claiming it was broken. The AP boots up, i can access it from terminal/CLI, log in,
    erase old config from flash etc. but it can't enter configuration mode!

    Also tried hard reset with button in front to revert to factory defaults, but no success..

    When entering commands like "conf t", "copy tftp..." etc. from privileged mode (#) i get:
    % Invalid input detected at '^' marker. Other commands like "show running..", "show ver" etc. works just fine.

    Into the trashcan or is it repairable?
     
    Slaarne, Apr 12, 2012
    #1

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Wavelan Bronze and AIR-AP350 and AIR-AP340

  2. Cisco Aironet 1130AG Boot Loader question

  3. Where to get Cisco Aironet 1130AG Boot Loader software

  4. Nike Air Force Ones,Air Force One Air Force One-1,25th anniversary

  5. Nike Air Force Ones,Air Force One Air Force One-1

  6. Cisco Airnoet 1130AG + Funk Steel Belted Radius

  7. Nike air force one, air force 1, air force one low cut, air force one

Loading...