Cisco 678 (v 2.4.8) filter not working - please help

Discussion in 'Cisco' started by gkelly, Jan 8, 2005.

  1. gkelly

    gkelly Guest

    I have a Cisco 678 - v 2.4.8 DMT mode

    I have the following filters setup and it doesn't work.

    set filter 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 reset

    set fi 0 on allow outgoing all 10.0.0.12 255.255.255.255 0.0.0.0 0.0.0.0
    set fi 1 on deny outgoing eth0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 protocol tcp
    srcport 1-65535 destport 80-80
    set fi 18 on allow incoming all 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
    set fi 19 on allow outgoing all 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0

    I only want 10.0.0.12 to be allowed access to port 80. All other IP's
    will be block if trying to access this port.
    As for all other IPs and Port - allow everything.

    Problem: It still allows everyone access to port 80. Anybody know why?

    gkelly
     
    gkelly, Jan 8, 2005
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.