Cisco 3620 routing problem

Discussion in 'Cisco' started by dropper, Dec 27, 2003.

  1. dropper

    dropper Guest

    Can any one help

    I am responsible for installing a 3620 with 1 nm4t module and 1fe2w
    module with a wic1 card installed.
    Have 4 remote sites with seperate private addresses routing through
    2mb serial ports on the nm4t module links via the wic1 card on the
    1fe2w to a sixth site for email and internet access.
    The 4 remote sites work fine for internet and email but the site with
    the 3620 which is connected to the local lan via the ethernet port,
    can ping and trace route to the sixth site but users cannot browse the
    internet or pick up email from an exchange 2000 server.
    We have a very simple config using unnumbered links routing is done
    via eigrp which works fine on the remote sites.

    any ideas please

    Dropper
     
    dropper, Dec 27, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.