cdrom installation

Discussion in 'Computer Information' started by colin, Oct 16, 2003.

  1. colin

    colin Guest

    I have a relatively old CDRW installed on my machine. Today I acquired a
    52x cdrom. If I install this as slave, will it run at 52x or will it run at
    the speed of the original cdrom (12x).

    If it runs at the speed of the cdrw, is there any way to get it to run at
    proper speed?

    Also, if I change them around and make the 52x as master and 12x as slave,
    will the 12x suffer any problems from being slave to a faster drive?

    Many thanks

    Colin
     
    colin, Oct 16, 2003
    #1
    1. Advertisements

  2. colin

    Night_Seer Guest

    I would put the new drive as master, but there shouldn't be a problem, it
    will run at its best speed.
     
    Night_Seer, Oct 17, 2003
    #2
    1. Advertisements

  3. colin

    Thor Guest

    It should run just fine. Unless you have an ancient chipset, the independent
    timing support will enable each device to run at their proper speeds.

    ...
     
    Thor, Oct 17, 2003
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.