cant run commands

Discussion in 'Cisco' started by Mr Cisco Man, May 28, 2005.

  1. Mr Cisco Man

    Mr Cisco Man Guest

    Hello!
    I have some cisco 2600 series routers and a 3620 router. I am trying
    to study for the SECUR exam. In the book it says to run the new
    commands that start with security I need IOS 12.3(1)
    but when I load that IOS the commands never appear in enable mode
    COmmand examlpe
    security authentication failure rate

    Router(config)#security ?
    % Unrecognized command
     
    Mr Cisco Man, May 28, 2005
    #1
    1. Advertisements

  2. Mr Cisco Man

    Guest Guest

    then is not there, ask the tac to do a cross check in the feature navigator
    for you and find out why those features are not there.

    --
    2nd Law of Thermodynamics: Chaos will Reign.

    ///////////////////
    --Anthrax--
    //////////////////
     
    Guest, May 28, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.