bridging over a t1 between cisco 2611 and cisco 7206

Discussion in 'Cisco' started by Chad Whitten, Feb 17, 2004.

  1. Chad Whitten

    Chad Whitten Guest

    this is a temporary setup to extend a network to a new location to faciliate
    moving entire network. any sample configs?

    basically ive done this so far on each router

    interface Ethernet0/0
    ip address 206.xxx.xxx.xxx 255.255.255.0
    ip directed-broadcast
    no ip mroute-cache
    half-duplex
    bridge-group 1
    !
    interface Serial0/0
    no ip address
    no ip mroute-cache
    bridge-group 1

    is that all thats needed?

    what kind of performance/speed/throughput is expected here?

    --
    Chad Whitten CCNA
    Network/Systems Administrator
    neXband Communications

    601-944-4801
     
    Chad Whitten, Feb 17, 2004
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.