bridge between cisco 3640 and intel 9100

Discussion in 'Cisco' started by popo, Mar 16, 2006.

  1. popo

    popo Guest

    Hi

    I have problem with this. I need have bridge between s1/0.7 and FE2/1 in
    cisco and lan and wan port in intel.
    I choose lan and wan interface and mark Wan bridging. In cisco i receive
    packet only from cisco Fe2/1. I try with bridge ieee and dec. On the rest of
    subinterface in cisco i must have ip routing so i cannot use command: " no
    ip routing". Yesterday, when i connect two cisco routers with ours help, it
    does works but today between intel and cisco didn't works

    thx for help or clue
    best regards
    popo

    In cisco i have:

    interface Serial1/0
    description 41216084
    no ip address
    no ip proxy-arp
    encapsulation frame-relay IETF
    no ip route-cache cef
    no ip route-cache
    no ip mroute-cache
    load-interval 30
    frame-relay lmi-type ansi
    bridge-group 1

    !
    interface Serial1/0.7 point-to-point
    description Warszawa ILMET
    no ip route-cache
    no ip mroute-cache
    no cdp enable
    frame-relay interface-dlci 102
    bridge-group 1
    !
    interface FastEthernet2/1
    no ip address
    no ip route-cache cef
    no ip route-cache
    no ip mroute-cache
    duplex auto
    speed auto
    arp timeout 120
    no cdp enable
    bridge-group 1
    !

    bridge 1 protocol dec


    sh bridge verbose

    Total of 300 station blocks, 299 free
    Codes: P - permanent, S - self

    BG Hash Address Action Interface VC Age RX count TX
    count
    1 2D/0 00d0.9680.3518 forward FastEthernet2/1 - 0 3
    0
    1 4D/0 0011.8521.e4a9 forward FastEthernet2/1 - 0 1
    0
    1 AE/0 0004.75d5.5ef0 forward FastEthernet2/1 - 0 1
    0
    1 D4/0 0001.02df.26f2 forward FastEthernet2/1 - 0 3
    0

    Flood ports (BG 1) RX count TX count
    Serial1/0 0 0
    Serial1/0.7 0 0
    FastEthernet2/1 0 0
     
    popo, Mar 16, 2006
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.