access lists for two lans

Discussion in 'Cisco' started by Infania, Jan 20, 2005.

  1. Infania

    Infania Guest

    Hey, if i have interfaces with ip 192.168.1.10 and 192.168.0.10 and
    want to route everything between this lan,s , what access lists should
    i make??

    /Mattias
     
    Infania, Jan 20, 2005
    #1
    1. Advertisements

  2. Infania

    BradReeseCom Guest

    BradReeseCom, Jan 20, 2005
    #2
    1. Advertisements

  3. :Hey, if i have interfaces with ip 192.168.1.10 and 192.168.0.10 and
    :want to route everything between this lan,s , what access lists should
    :i make??

    Access lists are primarily for -blocking- communications. If you want
    all the communications to flow then you would not normally put
    in any access-list at all.

    Perhaps you were really asking about what routing entries you should
    put in? If so then the answer is that if you are using IOS then
    as long as you have turned on routing ('ip routing') then you do
    not need to configure any routes in order for traffic to flow between
    IP ranges that fall into the ranges configured for each interface.
     
    Walter Roberson, Jan 20, 2005
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.