827-4v & netmeeting

Discussion in 'Cisco' started by gabriele, Jul 8, 2003.

  1. gabriele

    gabriele Guest

    hi NG

    I got my 827-4v calling from netmeeting to POTS and reverse in the LAN, but
    I cannot manage to call from a netmeeting (configured gateway public IP
    address of router) by internet.

    netmeeting>-- internet -- > Dialer1 > ---- POTS > --- telephone this
    doesn't work

    netmeeting <> LAN <> Ethernet <> POTS <> telephone this works

    any suggestion?

    many thanks

    some debug:

    ########## this when i try to call from intenet:

    show voice call 1
    1 - - - vpm level 1 state = FXSLS_ONHOOK
    vpm level 0 state = S_UP

    ########## this when i try to call from LAN:

    Jul 7 13:08:06: [1, FXSLS_ONHOOK, E_HTSP_SETUP_REQ]
    fxsls_onhook_setuphtsp_progress


    marge#show voice call 1
    1 vtsp level 0 state = S_SETUP_REQ_PROC
    vpm level 1 state = FXSLS_WAIT_OFFHOOK
    vpm level 0 state = S_UP

    marge# ***DSP VOICE TX STATISTICS***
    Tx Vox/Fax Pkts: 0, Tx Sig Pkts: 0, Tx Comfort Pkts: 0
    Tx Dur(ms): 0, Tx Vox Dur(ms): 0, Tx Fax Dur(ms): 0
    ***DSP VOICE RX STATISTICS***
    Rx Vox/Fax Pkts: 0, Rx Signal Pkts: 0, Rx Comfort Pkts: 0
    Rx Dur(ms): 0, Rx Vox Dur(ms): 0, Rx Fax Dur(ms): 0
    Rx Non-seq Pkts: 0, Rx Bad Hdr Pkts: 0
    Rx Early Pkts: 0, Rx Late Pkts: 0
    ***DSP VOICE VP_DELAY STATISTICS***
    Clk Offset(ms): 0, Rx Delay Est(ms): 60
    Rx Delay Lo Water Mark(ms): 60, Rx Delay Hi Water Mark(ms): 60
    ***DSP VOICE VP_ERROR STATISTICS***
    Predict Conceal(ms): 0, Interpolate Conceal(ms): 0
    Silence Conceal(ms): 0, Retroact Mem Update(ms): 0
    Buf Overflow Discard(ms): 0, Talkspurt Endpoint Detect Err: 0
    ***DSP VOICE ERROR STATISTICS***
    Rx Pkt Drops(Invalid Header): 0, Tx Pkt Drops(HPI SAM Overflow): 0

    marge#htsp_release_req: cause 31, no_onhook 0
    Jul 7 13:09:30: [1, FXSLS_WAIT_OFFHOOK, E_HTSP_RELEASE_REQ]
    fxsls_waitoff_release
     
    gabriele, Jul 8, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.