3Com Etherlink III 509b-Combo - NT4 and switch to RJ45

Discussion in 'Home Networking' started by Robert Secon, Jul 22, 2003.

  1. Robert Secon

    Robert Secon Guest

    I have WIN NT 4 and a 3COM Etherlink III with BNC and RJ45. Network just
    worked fine with BNC, but now our institute switched from BNC to ISDN, so I
    have to change from BNC to RJ45. I´ve tried it manually through MS-DOS
    bootdisc with an ****.cfg file to fix it, and I switched it there, but there
    is still no link. Is it an NT4 problem? What can I do?
    Robert Secon, Jul 22, 2003
    1. Advertisements

  2. Robert Secon

    Bernard Peek Guest

    Your reference to ISDN confuses me. Are you sure that's what you meant?
    You can't plug a network card into an ISDN service, it won't work and
    you may damage something.

    Go to Control Panel, Networks, Adapters and select properties of the
    Etherlink III. I believe there is a setting that you may need to change,
    but it's a long time since I used one of those cards. Can you confirm
    that your network is compatible with 10Mb network cards?
    Bernard Peek, Jul 23, 2003
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.