1601 can't see WIC on boot...?

Discussion in 'Cisco' started by JNJ, Jul 9, 2003.

  1. JNJ

    JNJ Guest

    We have a Cisco 1601 with a T1 WIC inserted. For some reason, it cannot
    seem to use the WIC on boot -- it gives the following error each time:

    %C1600-4-BADINTFC: Interface 2, (0-1 Onboard interfaces 2=WIC)
    Invalid interface (Unknown, Uninitialized or Bad Cookie value read)

    %C1600-4-INTFCNOFLH: Unable to load images or communicate over
    interfaceprogram load complete, entry point: 0x8000060, size: 0x519df0

    If we manually rewrite the config to memory all is well...until we restart
    the router at which point it again tosses out the above errors.

    JNJ, Jul 9, 2003
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.