A "debug ip nat" will help you figure it out. For the internal mail server to always use the same public IP you need to have a static nat...
I have seen this before odds are the Netgear is going to auto negotiate the authentication type while the firewall is hard coded to only set it up...
The command is same-security-traffic permit intra-interface
Add a second NIC to your web server give it an internal ip address and then point the internal users to the inside web address instead of the...
You can do that by simply adding the log command to the end of the specific access list entry so it will be the only thing logging.
Make sure HTTP server is enabled in the config. Make sure you can locate the gui in flash.
access-list inbound extended permit ip any any
access-group inbound in interface outside
You should edit your message and take your ip...
Can vlan 2 ping its own default gateway? Check the route tables and make sure you see a route to the opposite side.
You mean the guy who has is doesnt know the password so he cant get into it? Then yes when you get it you can get it set back to default factory...
From configuration mode:
Assuming these switches are in transparent mode or your switch is a server in vtp....
Are you configuring it to be a trunk or an access port? What is it provisioned for on the nortel side?
Start with upgrading your IOS to 6.3 (5). The version of the vpn client (4.6) doesnt work with anything below 6.2 per this doc:...
Why would you ever want a computer to be turned on and automagically get into your network.
No thats pretty much it. By default no traffic is allowed until you specify it which is done in an ACL.
this doc should help
Separate names with a comma.