load balancing with cisco

Discussion in 'Software' started by hariharasudhan, Apr 7, 2007.

  1. hariharasudhan

    hariharasudhan

    Joined:
    Apr 7, 2007
    Messages:
    1
    I Have to E1, i have cisco 2621 with 2MFT VWIC. Can i load balance two E1 with the VWIC. How to do NAT for this.

    Please help me out on this.
     
    hariharasudhan, Apr 7, 2007
    #1
    1. Advertising

  2. hariharasudhan

    rmundy

    Joined:
    May 27, 2010
    Messages:
    10
    Hariharasudhan,

    The easiest way to do load balancing will be to use PPP Multilink configurations on either end of the E1s. These would be seen and treated as a single interface and the IP address would be assigned to the one, logical Multilink interface. See Cisco Document ID: 10380 for more info.

    There are also ways to load balance with routing protocols, but this get more complicated and in-depth. Cisco Document ID: 5212 does discuss this in quite a basic form but would be a good starting place.
     
    rmundy, May 27, 2010
    #2
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. Adam
    Replies:
    0
    Views:
    3,813
  2. a_janssen
    Replies:
    1
    Views:
    2,559
    Craig
    Oct 20, 2003
  3. shailu
    Replies:
    0
    Views:
    566
    shailu
    Oct 21, 2003
  4. ciscortp@hotmail.com

    Load Balancing / Load Sharing over parallel paths

    ciscortp@hotmail.com, Nov 21, 2005, in forum: Cisco
    Replies:
    1
    Views:
    2,349
    Vincent C Jones
    Nov 21, 2005
  5. palas_123
    Replies:
    1
    Views:
    2,111
    donjohnston
    Dec 28, 2009
Loading...

Share This Page