implementing failover capabilities

Discussion in 'Cisco' started by lelo, May 19, 2005.

  1. lelo

    lelo Guest

    There were two separate networks which resided in two different
    buildings at my company's present location which have since been
    merged into one network which spans two buildings. Each of these
    networks had it's own cisco 2610 router connected to a full T1 line
    for internet access. Both of these networks had different internet
    service providers. Now that the networks have been merged into one all
    of the equipment is now going to be housed in one building. One of the
    ISPs (AT&T) has agreed to move its' circuit into the new building. Is
    there anyway to utilize only one of the cisco 2610 routers to host both
    of the 2 different ISP providers circuits in some type of failover
    configuration so that if one isp's circuits goes down the other would
    take over. What additional router hardware would we need in order to
    accomplish this. Any help would be greatly appreciated. Thanks in
    advance, LeRoy.
    lelo, May 19, 2005
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. qod
    Replies:
    3
    Views:
    590
    MCSE World
    Dec 3, 2003
  2. Mr_Magoo
    Replies:
    6
    Views:
    13,055
    Mr_Magoo
    May 8, 2004
  3. Alec Waters
    Replies:
    0
    Views:
    1,486
    Alec Waters
    Jun 9, 2004
  4. Mirko
    Replies:
    2
    Views:
    619
    Mirko
    Aug 30, 2004
  5. Pit
    Replies:
    0
    Views:
    1,114
Loading...

Share This Page