Encapsulation problem

Discussion in 'Cisco' started by Tricon7, Sep 9, 2007.

  1. Tricon7

    Tricon7

    Joined:
    Sep 8, 2007
    Messages:
    1
    I should be able to create a sub-interface on the router and give it an encapsulation type, like dot1q or isl. But after I've created the sub-interface, there are no encapsulation options. I even typed a "?" at the prompt, and "encapsulation" didn't appear. I'm reading right out of Cisco's book right now, and I know that sequence and procedure is right, so I'm puzzled as to why it won't accept it. And if I try and assign an IP address to a sub-interface, I get the message:

    Configuring IP routing on a LAN subinterface is only allowed if that subinterface is already configured as part of an IEEE 802.10 or ISL vLAN.

    Suggestions?
     
    Tricon7, Sep 9, 2007
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. brian
    Replies:
    1
    Views:
    476
    Walter Roberson
    Nov 28, 2003
  2. anth0
    Replies:
    0
    Views:
    604
    anth0
    Dec 18, 2003
  3. MaDuNiX

    encapsulation

    MaDuNiX, Jan 8, 2004, in forum: Cisco
    Replies:
    3
    Views:
    4,122
    scott enwright
    Jan 9, 2004
  4. Andy Lawson
    Replies:
    0
    Views:
    445
    Andy Lawson
    Jan 21, 2004
  5. FeatureBug
    Replies:
    3
    Views:
    14,667
    Ivan Ostres
    Sep 3, 2004
Loading...

Share This Page